Electroplasticity mechanism of Ti2AlNb alloys under hot compression with the application of a lower electric current

Abstract

In this study, a lower electric current (1.0–2.0 A/mm2) was applied during hot compression of Ti2AlNb alloys, and the mechanical response, microstructure evolution, and electroplasticity mechanism were investigated. The results showed that the maximum flow stress drop could reach 18.7 % after applying a lower electric current of 2.0 A/mm2, which confirms the existence of electroplasticity. The stress drop increased with increasing electric current density. However, the flow stresses of the samples in the isothermal compression test and those subjected to a 1.0 A/mm2 electric current compression test were similar, indicating that there is a threshold value for the electroplasticity effect on flow stress. The lower strain hardening rate caused by the electric current confirmed the electroplasticity effect, promoting the softening effect. Additionally, the lower average activation energy Q, affected by the electric current, implied the improvement of the deformability of the alloy due to the deformation mechanism of dynamic recovery (DRV), dynamic globularization, or dynamic recrystallization (DRX). The gradual reduction of dislocation density with increasing electric current density resulted in the stress drop, which can be ascribed to the directional drifting electrons colliding with dislocations, which promoted the movement of dislocations by arranging the dislocations in parallel. The local high temperature induced by the local Joule heating effect at the O lamella had a strong promoting effect on the globularization of the O lamella by producing uniform lattice distortion/local strain at the O/B2 interface. With increasing furnace temperature, the drifting electrons accelerated the transformation of LAGBs to HAGBs which promoted the appearance of dynamic recrystallization grains.