Electron Microscope Studies of the 01Cr17Ni13Mo3 Austenitic Steel Structure after Cold Rolling Combined with Hydrogen Alloying with Varying Degrees of Deformation

Abstract

In this paper, we consider the effect of cold rolling and hydrogen alloying on the formation of twin boundaries of the corrosion resistance of austenitic steel 01Cr17Ni13Mo3. Using the method of transmission electronic microscopy, microdiffraction patterns were obtained. The analysis of microdiffraction patterns indicates the formation of a developed grain-subgrain structure with small-angle and large-angle misorientation. The structure has a high dislocation density, deformation twins and localized shift bands. It was established that plastic deformation by flat rolling to ε = 90 % at room temperature does not contribute to the appearance of a noticeable amount of α' and ε-martensite. At the temperature of liquid nitrogen, the samples were found to form a small fraction of the α'-martensite phase. Such a small amount of martensite can contribute to steel strengthening, and a decrease in the rolling temperature will lead to an increase in the strength properties of steel. It was detected that the density of twin boundaries under the decrease in the rolling temperature but with the same intensity of hydrogen saturation is significantly higher. A noticeable reduction in the width of the twin lamellas was revealed.