Year-end Sale % OFF 
Abstract
In this study, fore-vacuum plasma electron beam sources were used to deposit a few micron-thick boron coatings on A284 and ZrNb1 alloys and modify their surfaces. The coating deposition rate with a continuous 1 kW electron beam that evaporated the boron target at a distance of 10 cm was 0.5 µm/min, and the boron coating density was 2.2 g/cm3. Based on the comparison of data on the mass-to-charge composition, beam plasma density, and coating parameters, the contribution of the plasma phase of the evaporated material to the growth of coatings was greater than that of the vapor phase. Using the scanning electron and atomic force microscopy techniques, surface modification by repeated electron beam pulses with electron energies of 8 and 6 keV and a beam power per pulse of 2 J/cm2 and 2.25 J/cm2, respectively, transformed a relatively smooth coating surface into a hilly structure. Based on a structural phase analysis of coatings using synchrotron radiation, it was concluded that the formation of the hilly coating structure was due to surface melting under the repeated action of electron beam pulses. The microhardness, adhesion, and wear resistance of coatings were measured, and their corrosion tests are presented herein. The pure boron coatings obtained and studied are expected to be of use in various applications.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
