Abstract

Irradiation of polymers is one of the most effective and economical methods for modifying their properties and for changing their applications. In this study, an extrusion grade polypropylene (PP) was treated by electron beam irradiation to produce a PP suitable for injection molding. Irradiation was carried out at different doses (0-80 kGy) under atmosphere air and at ambient temperature. Melt flow index (MFI) measurements showed PP samples irradiated in the range of 10 to 40 kGy are suitable to use in injection molding. Electron beam irradiation decreased the viscosity and the shear thinning rheological behavior of PP. The differential scanning calorimetry (DSC) analysis revealed that electron beam irradiation increased the crystallinity percentage and temperature of PP, but decreased the melting temperature. Among all treated samples, the PP20, irradiated at the dose of 20 kGy, showed the highest impact resistance. It had higher Young’s modulus and tensile strength, but lower elongation-at-break in comparison with untreated PP.

Full Text

Paper version not known (Free)

Published Version

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.