Abstract
A 512 kbit read-only memory (ROM) to store Chinese ideographs has been fabricated using variable-shaped electron beam and dry-etching lithography. 1.0-µm minimum line width was used to delineate device area spacings smaller than those obtained with conventional design rules using photoimaging techniques. SiO 2 , Si 3 N 4 , and polysilicon etchings were accomplished by reactive sputter techniques with CF 4 + H 2 and CCl 3 F gases using negative electron beam resist PGMA and positive resist AZ-2400. Al etching was carried out by plasma with CCl 4 gas using negative electron beam resist NER-1. The alignment marks detectability and their locating accuracy were improved by properly using the basis arithmetic operations, subtraction and summation, in backscatter signal processings. 6.6 mm × 8.9 mm chip-by-chip alignment yielded about 0.2-µm level-to-level registration accuracy. Memory cell size and chip size are 5.2 µm × 8.4 µm and 6.6 mm × 8.9 mm, respectively; access time and power dissipation are 400 ns and 800 mW, respectively.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
