Abstract
Abstract An experimental study was performed to compare the electro-mechanical response of three-dimensionally conductive woven carbon fiber/epoxy laminated composites under quasi-static uniaxial tensile and in-plane shear loading conditions. Three-dimensional (3D) electrical network was generated in these composites by embedding carbon nanotubes (CNTs) of 0.025 wt% in the epoxy and reinforcing short carbon fibers (150 μm and 350 μm long) with a fiber density of 1000 fibers/mm2 between the laminates using electro-flocking process. CNTs are effectively dispersed in the epoxy matrix using a combination of ultrasonication and shear mixing techniques. A compression molding fabrication technique was employed to fabricate composite materials. For all composite types, in general, the in-situ electrical response showed a trend of initial decrease in resistance and later increase in resistance for tensile loading. However, no noticeable increase in electrical resistance was observed until failure of the composite under shear loading conditions. Both CNTs and short carbon fibers made new contacts with neighboring carbon fiber laminates for entire duration of shear loading even though the composite was undergoing progressive failure.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
