Abstract
Graphene–polyamide-6 composite (GC) filament was 3D-printed via melt extrusion (ME). The influence of specimen thickness and internal geometric designs on electromagnetic interference shielding effectiveness (EMI SE) and dielectric properties in the X-band frequency range (8.2–12.4 GHz) was investigated. Increasing specimen thickness from 1 to 5 mm did not improve EMI SE due to impedance matching and the associated reductions in electromagnetic (EM) wave reflection. It was demonstrated that the introduction of suitable internal geometric assemblies avoided impedance matching and significantly improved EMI SE. A material model for simulating EM response of 3D-printed GC was developed and experimentally verified. It was found that different internal geometric designs each displayed unique EM responses. However, geometrical inaccuracies in printed specimens resulted in differences between experimental EM response and that predicted by simulations. These inaccuracies stem from the small size of the features relative to the printer resolution and the ME printing methodology. Therefore, the limitations of a printer when replicating complex geometries must be considered to effectively apply internal geometric designs for enhancing EMI SE of 3D-printed components.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
