Abstract

In this work, nanostructured thin films of ZnO were electrochemically grown on FTO substrates. The morphology was tuned by modifying the synthesis parameters. The synthesis was carried out by applying Zn(NO3)·6H2O as the sole component of the aqueous electrolyte, avoiding the use of capping agents. The composition and morphology of the prepared ZnO were characterized by energy-dispersive X-ray spectroscopy (EDX) and scanning electron microscopy (SEM), respectively. The as-deposited films were applied as electrodes in dye sensitized solar cells (DSCs). The performance of the cells was investigated by J×V curves and IPCE (incident photon to charge carrier efficiency) measurements. The SEM analysis demonstrated a direct relationship between ZnO morphology and Zn precursor concentration. It has been shown that the lower the concentration is, the more porous the morphology is. Increasing the amount of dye adsorbed on the ZnO decreased the power conversion efficiency of the final DSCs. The best cell presented the following parameters: open circuit voltage VOC=0.59V, short circuit current JSC=7.64mA/cm2, fill factor FF=50.41%, and power conversion efficiency PCE=2.27%.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.