Electrochemical synthesis and characterization of conducting copolymers of biphenyl with pyrrole

Abstract

AbstractCopolymer films of biphenyl and pyrrole were synthesized by electrochemical polymerization. The influence of the applied potential used for the electropolymerization on the structure, morphology, electrical conductivity, and stability of the films was examined. From the analysis of the current–time curves, it was found that the growth of the copolymer films starts immediately. The films were characterized by Fourier transform infrared spectroscopy (FTIR), thermogravimetric analysis, X‐ray diffraction analysis, and scanning electron microscopy–energy‐dispersive X‐ray analysis, and their electrical conductivity (σ), energy gap (Eg), and electrochemical stability were also determined. Based on the results, the copolymers were classified into three groups. The first includes the (PP‐PPy)0.80 copolymer synthesized at the lowest potential Eox (0.80 V), having the highest ratio R (R = 0.35) of quinoid to benzenoid rings (calculated from FTIR), the highest value of σ (σ = 0.9 S/cm), the lowest Eg (Eg = 1.20 eV), and has compact morphology. The second group concerns the copolymers synthesized at higher potential (0.82 up to 0.86 V), having lower R (∼ 0.20), lower σ (below 0.4 S/cm), higher Eg (∼ 1.35 eV), and they are less compact with many pores. The third group includes the copolymers synthesized at even higher applied potential (0.88 and 0.90 V), having even lower R values (∼ 0.10), significantly lower σ (∼ 10−3 S/cm), even higher Eg (∼ 1.70 eV), and they are very porous. The applied potential during electropolymerization strongly affects the properties of the synthesized copolymers. Because of the combination of high conductivity, low energy gap, and partial solubility with significant electrochemical stability, these new copolymers are attractive candidates for many applications. © 2012 Wiley Periodicals, Inc. J Appl Polym Sci, 2012