Electrochemical studies of octadecanethiol and octanethiol films on variable surface area mercury sessile drops

Abstract

Octadecanethiol (ODT) and octanethiol (OT) films at the mercury-electrolyte interface are examined using cyclic voltammetry and differential capacitance measurements at a single frequency. A mercury flow-system is used to alter the volume, and therefore, the surface area and surface pressure of the mercury electrode. Manipulation of the mercury electrode's volume enables the introduction and removal of defects in the insulating thiol films. OT and ODT film behavior are contrasted under conditions of expansion and contraction. ODT forms extremely impermeable layers that allow 1000 time less redox probe current than seen on uncoated drops. Expansion of the mercury electrode to increase the electrode surface area produces defects and pinholes in the thiol film. These defects are almost completely removed when the drop is compressed back to its initial surface area. OT also forms insulating films on mercury sessile drops, however these films contain more defects than ODT films. While expansion of an OT-coated mercury drop increases redox probe current, recompression of the drop does not return the film to its initial condition. Pinholes and defects in the OT and ODT films can also be produced by cycling to negative potentials, which produce abrupt stripping peaks.