Abstract
Iron contamination in groundwater has attracted much attention from environmentalists and government agencies because it can cause many problems in human life and in industrial and agricultural activities when groundwater is directly used without any treatment. This study aims to investigate the electrochemical oxidation of Fe(II) to Fe(III) and recovery of insoluble Fe(III) using non-corrosive graphite electrode which serves as a controllable, low-cost, low maintenance and virtually unlimited electron acceptor for Fe(II) oxidation. The lab-scale results indicated that Fe(II) removal up to 100% was obtained at an applied voltage higher than 2 V. The Fe(II) removal efficiency was linearly increased with the increase of potential supply in the range of 1–4 V in the salinity 0.5%. The Fe(II) removal rate could no longer be enhanced at the applied potential higher than 8 V in the condition without salinity. The results from SEM-EDS and XRD revealed that Fe was recovered as FeOOH by conventional filtration with a recovery efficiency of 82.7–92.1%. The electrochemical Fe(II) removal might be an alternative for the conventional method of the in situ Fe removal from groundwater. Besides, the recovered FeOOH can be used as a raw material for environmental remediation and pigment industry.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.