Electrochemical Recovery of N and P from Municipal Wastewater

Abstract

Phosphorus, P, is a vital element of paramount importance for both humans and for the Environment. Wastewater contains often relatively high concentrations of P which can be recovered as crystalline struvite (MgNH4PO4·6H2O, MAP). This option is quite attractive in assisting sustainable development because struvite can be used as a slow-release fertilizer. Domestic wastewater is usually high in P and nitrogen, N, but relatively poor in magnesium, Mg. It is necessary to develop low-cost solutions for the enrichment of wastewater with Mg. In the present work, sacrificial magnesium anodes were used, which dissolve upon anodic polarization, releasing sufficient magnesium for the selective precipitation of MAP. The application of constant current between two electrodes of which the anode is a low-cost magnesium cylindrical rod (4 cm2 exposed surface area) and the other a platinum cathode electrode, both immersed in ammonium phosphate solutions, without adjustment of the solution pH, was investigated. Constant current density over the range 10–100 A·m−2, between the Mg- Pt electrodes immersed in solutions of ammonium hydrogen phosphate of exactly known initial concentration, was applied using a potentiostat. In the presence of sodium chloride solutions, on the magnesium anode and in the bulk solution, Mg(OH)2 (brucite) formed because of the passivation of the Mg electrode. In dilute ammonium hydrogen phosphate solutions, the magnesium anode dissolution resulted in struvite precipitation, even at a low applied current (10 mA). Struvite crystals with an average size of 20 μm were precipitated. The behavior of the cell for the electrolyte solutions used was Faradaic as long as the surface coverage of the anode was relatively low. The anodic dissolution of Mg resulted in high pH values (pH 11) eliminating the need for alkali addition.