Abstract
A soft magnetic CoNiFeS film as a write head core material for the next generation was prepared by electrodeposition. In this system, thiourea was used as an additive in the CoNiFe ternary alloy plating bath. The most suitable magnetic properties were obtained at the film composition of [atomic percent (a/o)] with a high saturation magnetic flux density of 1.7 T, a high resistivity (ρ) of 51 μΩ cm, and a low saturation magnetostriction (λs) of . The film consisted of fine minute crystal grains 5 to 10 nm in diameter. The S content of ca. 0.9 a/o is believed to be responsible for the formation of small crystal grains with low coercivity and high resistivity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
