Abstract
Introduction Secondary battery materials are in great demand of research and new high energy density materials are required for higher quality of batteries1. Silicon based anode is one of the most promising anode material for Li-ion batteries, because it has high theoretical capacity (4200 mAh/g, lithiated to Li4.4Si) and low operating voltage (~0.3V versus Li/Li+) 2,3 Challenges for silicon based anode are the capacity fading during the first cycle and the poor cycle performance. Experimental Si layers on copper foil were produced by Picodeon’s ultra-short pulsed laser deposition (USPLD) technology. This technology utilizes pulsed lasers with pulse lengths in the picosecond range and high pulse repetition rates (MHz). The pulsed laser beam is delivered to the surface of the target, which is placed inside a vacuum chamber, through a scanner and a telecentric lens. With this beam delivery approach a focused scan line can be produced on the target. Material is removed by the laser pulses from the target material, and movement of the substrate through the material cloud generated by this line source enables straightforward deposition of uniform layers even on larger surface areas. Cells with USPLD prepared Silicon anode and LiNi0.5Co0.2Mn0.3O2 cathode were prepared in the humidity controlled dry room. Cathode thicknesses were controlled to have different specific capacities for the silicon anode material. Different type of electrolytes and testing parameters were used to achieve better electrochemical results for USPLD silicon anodes. Results and discussion Results showed that electrochemical testing parameter and materials used in the tests have great influence on the electrochemical performance of silicon anode materials. Especially, additives used in the electrolyte seems to have a great influence on the cycle performance of silicon based anode material. Results also showed that silicon material should not charge full, instead 1500 mAh/g show much better electrochemical properties. Results also clarified some problems with half-cell and full-cell tests. We have demonstrated that the 10µm thick 100% silicon anode layer prepared by USPLD can replace 50µm graphite layer in the Li-ion cell. Total energy density is higher for silicon-NCM cell than for graphite-NCM cell after hundred cycles. Still challenge is the poor cycle performance compared to graphite anode; however, results showed that it is possible to improve cycling properties by electrolyte additives and limiting charging capacity. Silicon based anode material is a good candidate for the next generation Li-ion battery. Reference s : W Choi and D. Aurbach (2016) Nature rewiew materials 1. (2016) 16013A Huggins (1999) Journal of Power Sources, Vol 81-82, pp.13-19Hui Wu, Yi Cui (2012) Nanotoday, Vol 7, issue 5, pp 414-429
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.