Abstract
A low-cost screen-printed carbon electrode (SPCE) modified with Fe3O4, gold nanoparticles (AuNPs), and polyaniline (PANI) has been developed for rapid measurement of carcinoembryonic antigen (CEA) biomarker. The electrode surface was covered with Fe3O4 nanoparticles by drop coating then with PANI via electropolymerization. The resulting surface was further modified by AuNPs via electrodeposition. Key factors affecting the electrochemical behavior and sensing performance of the electrode were investigated. The results demonstrated that Fe3O4 mass loading of 2 mg/cm2 and 15 cycles of PANI polymerization were optimal for electrochemical measurement of CEA biomarker. In addition, compared with bare SPCE, coating the electrode surface with PANI, Fe3O4/PANI, and Fe3O4/PANI/AuNP significantly enhanced the peak oxidation current by approximately 16%, 52%, and 93%, respectively. The sensors exhibited linear trends with CEA concentration from 0 ng/mL to 10 ng/mL. The limit of detection and sensitivity of the electrode were estimated to be 0.25 ng/mL and 0.3827 μA/ng mL−1, respectively. Such sensors could be easily integrated into microfluidic platforms and could serve as a low-cost, rapid, point-of-care measurement method for CEA cancer biomarker.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
