Abstract
Electrochemically deposited Zn–Co alloys under various deposition conditions were investigated using anodic linear sweep voltammetry for phase structure determination, scanning electron microscopy for surface morphology analysis, atomic absorption spectroscopy for determination of chemical composition, and polarization measurements and open circuit potential measurements for determination of corrosion properties. The influence of deposition current density, temperature, and composition of deposition solution on the phase structure and corrosion properties of Zn–Co alloys was studied. It was shown that the ratio of cobalt to zinc ions in the plating bath strongly affects the chemical content and phase structure, as well as corrosion stability, of Zn–Co alloys. Zn–Co alloys deposited from plating baths with the lowest and the highest ratios of cobalt and zinc ions exhibited the lowest corrosion rate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
