Electrochemical Behavior of Cu-MWCNT Nanocomposites Manufactured by Powder Technology

Abstract

This paper presents an experimental investigation of the fabrication of Cu–multi-walled carbon nanotube (MWCNT) nanocomposites prepared via the electroless chemical deposition technique followed by the powder metallurgy (PM) method. To enhance the dispersion and wettability of MWCNTs with a Cu matrix, MWCNTs were given an electroless coating of Ag nanoparticles. MWCNTs with 0.4, 0.8, and 1.2 wt.% were first coated with 5 wt.% Ag nanoparticles, then mechanically milled with Cu nanoparticles using a 10:1 ball-to-powder ratio for 60 min at 300 rpm. The mixed samples (35 g) were subjected to a compression pressure of 700 MPa and sintered at 950 °C in a hydrogen-inert gas furnace. Mapping and microstructure analyses were conducted to analyze the constituents’ homogeneity. In addition, the electrochemical properties and corrosion resistance of specimens were investigated. The results revealed that the relative density decreased by raising the MWCNTs’ content. Electrical resistivity increased gradually with the addition of MWCNTs coated by Ag nanoparticles, and the thermal conductivity decreased. It was also revealed that the smallest corrosion rate could be obtained for the sample with 1.2 wt.% MWCNTs, which is the appropriate rate for the electrochemical deposition.