Abstract
The electrocatalytic reduction of hydrogen peroxide (H2O2) has been studied at nanostructured copper (Cunano) modified glassy carbon (GC/Cunano) electrode in phosphate buffer (pH 7.2). The electrical properties of GC/Cunano modified electrodes were studied by electrochemical impedance spectroscopy (EIS). Surface and electrochemical characterization were carried out by using atomic force microscopy (AFM) and cyclic voltammetry. A well-defined H2O2 reduction signal, which is due to mediation of a surface active site redox transition exhibits at the GC/Cunano electrode. The Cunano is acting as a bridge without the aid of any other electron mediator, which enables the direct electron transfer between the modified electrode and the substrate. The results are compared with bulk copper macroelectrode and emphasized the efficiency of the Cunano modified electrode. Systematic investigations were made to optimize the experimental parameter, such as applied potential (Eapp) for copper electrodeposition. The calibration curve obtained from chronoamperometric studies was found to be linear in the range 0.5 to 8.0 μM H2O2 with a detection limit of ca.10 nM (S/N = 3) at the GC/Cunano electrode. The modified electrode is stable for 1 week in phosphate buffer after repetitive measurements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.