Electrocatalytic oxidation of glucose at gold–silver alloy, silver and gold nanoparticles in an alkaline solution

Abstract

Listen

Translate article

Abstract Gold, silver and gold–silver alloy nanoparticles capped with decanethiolate monolayer shells (DT-Au, DT-Ag and DT-Au/Ag) were synthesized, with core sizes 2.3 (±1.0), 3.3 (±1.0) and 2.0 (±1.0) nm, respectively. To activate the synthesized nanoparticles for the electrocatalytic oxidation of glucose, nanoparticles were treated at 300 °C for 2 h. Heat-treated nanoparticles surfaces were characterized by FT-IR, X-ray photoelectron spectroscopy (XPS), thermogravimetric analysis (TGA), scanning electron microscopy (SEM) and cyclic voltammetry (CV). The elimination of C–H alkyl chains and thiolates from DT capped Au and Au/Ag nanoparticles was evident post heat-treatment by TGA, FT-IR and XPS investigations. In DT-Ag nanoparticles, C–H chains from DT were eliminated by heat-treatment, though thiolate was still present on nanoparticle surfaces. However, the thiolate from DT was eventually removed by further oxidation and reduction cycle treatments in an alkaline solution. After heat-treatment at 300 °C for 2 h, the surface content ratio of Au and Ag changed from Au:Ag(84:16) to Au:Ag(73:27). This tendency to increase the surface content ratio of Ag after heat-treatment was also observed in other Au–Ag alloy nanoparticle content ratios. Results from cyclic voltammograms at Au/Ag nanoparticles modified PFC electrodes in H 2 SO 4 and NaOH solutions indicated that the distribution of Au and Ag atoms of Au/Ag nanoparticles on nanocrystal surfaces is homogeneous. Electrocatalytic peaks for glucose oxidation in a 0.1 mol dm −3 NaOH solution were observed around −0.4 and 0.4 V (vs. Ag/AgCl) at heat-treated Au nanoparticle modified carbon electrode and around −0.4 and 0.6 V at heat-treated Au/Ag nanoparticle modified electrode, which correspond to the oxidation of glucose and further oxidation of gluconolactone generated by the first oxidation peak (−0.4 V), respectively. It is interesting to note that the catalytic current at Au/Ag nanoparticle modified electrodes was observed from ca. −0.75 V, which represents a negative potential shift of ca. 0.1 V compared to that at Au nanoparticle modified electrodes. This result indicates that Au–Ag alloy nanoparticles are effective catalysts for the electrocatalytic oxidation of glucose. At both Au and Au/Ag nanoparticles, aldose-type monosaccharides showed catalytic oxidation peaks in an alkaline solution, however ketose-type monosaccharides did not show any catalytic peaks in the potential region of −0.8 ∼ 0.8 V. After the controlled-potential electrolysis at a potential of −0.3 V, gluconolactone (or gluconate, a two-electron oxidation product) was only detected at a current efficiency of 100% at Au and Au/Ag nanoparticles modified carbon electrodes. In the case at 0.3 V, oxalate (an 18-electron oxidation product) and gluconolactone as the main product were detected at Au nanoparticle modified electrodes, and formate (a 12-electron oxidation product) in addition to oxalate and gluconolactone as the main products were detected at both Au/Ag and Ag nanoparticles modified electrodes. These results indicate that the catalytic selectivity at a potential of 0.3 V would be strongly governed by silver atoms containing Au/Ag nanoparticles surfaces.