Abstract
This paper presents a continuation about the effects of polyol synthesis conditions on the physicochemical and electrocatalytic characteristics of Pt-based alloys. Pt–Ru/C alloys with nominal Pt:Ru atomic ratio of 1:1 were synthesized by a polyol process with different ethylene glycol:ethanol:water volume ratios. The Pt–Ru/C catalysts were tested as anodes for the Ethanol and the Ethylene Glycol Oxidation Reactions. X-ray diffraction showed that the Pt–Ru/C catalysts have low crystallinity, which limited the analysis of some important factors such as average particle size, degree of alloying and lattice parameter. Such structural feature was attributed to a very small particle size, as confirmed by TEM analysis. The chemical composition by EDS indicated that the Pt:Ru 1:1 ratio can be achieved under most of the synthesis conditions. Moreover, the formation of oxides was a constant characteristic, whether water was present or absent during the synthesis. The electrochemical characterization showed that the synthesis conditions have an important effect on the electrocatalytic activity of the Pt–Ru/C alloys for both oxidation reactions. Compared to a Pt/C catalyst, all of the alloys showed lower onset potentials for the oxidation reactions, but several of them delivered smaller oxidation current densities.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
