Electricity generation using p-nitrophenol as substrate in microbial fuel cell

Abstract

The cell voltage and degradation rate of p-nitrophenol (PNP) were monitored in a two-chambered microbial fuel cell (MFC) system. Degradation metabolites in the anode solution of MFC were analyzed by gas chromatography–mass spectrometry (GC–MS). PNP was used as substrate by the MFC that was inoculated with anaerobic sludge. The results showed that electricity output increased with the PNP concentration increased, the MFC displayed a maximum power density of 1.778 mW m−2 and a maximum PNP degradation rate of 64.69% when PNP was used as a sole substrate. However, the cell voltage and the PNP degradation rate with sodium acetate (402.3 mV and 95.96%) were higher than those fed with glucose (341.9 mV and 83.51%) when glucose and sodium acetate were used as a substrate, respectively. Furthermore, GC–MS analysis showed that the PNP was biodegraded completely after 142 h in the MFC. These results demonstrate that PNP can be used for electricity generation in MFC for practical applications of wastewater treatment.