Electrical Resistivity Tomography and Ground-Penetrating Radar Measurements for Permafrost Detection on a Mountain Slope at Strandartindur, Seyðisfjörður - East Iceland

Abstract

In many regions of the Northern Hemisphere, permafrost is thawing due to climate change. In steep terrain, this permafrost degradation can affect slope stability. In one of Iceland's eastern fjords, Seyðisfjörður, nine major landslide cycles have occurred in the last century, originating from the lower parts (< 500 m a.s.l.) of the Strandartindur slopes, with the largest landslide event ever recorded in Iceland occurring in December 2020. Its triggering mechanism is being intensively studied and its development is being monitored. In addition to these instabilities, slow movements are also observed in the upper part (> 500 - 1010 m a.s.l.) of these slopes. In these upper areas, it is not known whether permafrost is present in the subsurface or what is causing it to creep downward. To further investigate the stability of these slopes, it is important to know and map the distribution and condition of possible permafrost layers. Therefore, electrical resistivity tomography (ERT) and ground penetrating radar (GPR) measurements were performed to study the presence and distribution of permafrost in the mountain, Strandartindur, above Seyðisfjörður. A combination of measurements is used as ERT responds primarily to the electrical resistivity of the subsurface, but this can depend strongly on other factors such as porosity, water content, etc., and GPR can help map the presence of different interfaces in the soil determined by their different physical properties, such as relative electrical permittivity, but also conductivity, which is the reciprocal of resistivity. Combining the two methods allows us to get a clearer picture of the subsurface. As a benchmark for ERT measurements in the field, a laboratory setup was performed with soil and rock samples at different temperatures and water saturations to study the behavior of frozen and non-frozen conditions in our geologic environment. With all of these measurements, we aim to answer the questions of whether permafrost is present in the selected area, what the distribution of permafrost is, whether we can use laboratory ERT to establish reference resistivity values, and if these methods are appropriate for this area.