Abstract
The electrical matching of low power piezoelectric ultrasonic transducers for microelectronic bonding is studied in this paper. The admittance characteristics of the transducers are described through admittance circle diagrams and the electrical matching analysis for the transducers is presented. The frequency ratio function has been introduced and analyzed. The result shows that the frequency ratio function increases with the static capacitance, dynamic capacitance and dynamic resistance, and decreases with the dynamic inductance. When the static capacitance, dynamic capacitance, dynamic resistance and dynamic inductance are small, there are little differences between the resonance frequency and the series resonance frequency, and it is not necessary to operate electrical matching when the frequency ratio function is less than 0.001. A typical low power piezoelectric transducer used in microelectronic bonding has been adopted to verify the results of electrical matching analysis. The analysis and experimental results show that the transducer can work well at its vibration frequency without electrical matching.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
