Abstract
AbstractA contactless method based on energy shift of high‐energy cut‐off of the x‐ray bremsstrahlung, the so‐called Duane Hunt Limit and a conventional low voltage electrical technique (three‐probes technique) is applied on thermal and corona aged silicone rubber (SiR) to measure, respectively, the surface potential,Vs, and the surface resistivity,ρs. The effect of aging on these quantities, representing the dielectric properties, is studied. The results are highly reproducible and highlight a good correlation betweenVsandρs. It was observed that thermal aging combined with electrical aging deteriorates more the electrical properties of the polymer than thermal aging alone. Explanations for electrical characteristics (Vs,ρs) change with aging are supported by attenuated total reflection Fourier transform infrared spectroscopy spectra analysis and a chemical mechanism of aging in three steps (i.e., oxidation‐polycondensation, degradation, and thermal cracking). The surface degradation of the polymer is revealed by images of surface morphology obtained by using scanning electron microscopy (SEM). Roughness is greater for combined thermal and corona aging mode compared to thermal aging alone. In addition, the surface degradation of SiR polymer is confirmed by the loss of its hydrophobicity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
