Abstract
Traditional cadmium sulfide (CdS) buffer layer in selenium-free Cu(In,Ga)S2 solar cells leads to reduced open-circuit voltage because of a negative conduction band offset at the Cu(In,Ga)S2/CdS interface. Reducing this loss necessitates the substitution of CdS by an alternative buffer layer. However, the substitute buffer layer may introduce electrical barriers in the device due to unfavorable band alignment at the other interfaces, such as between buffer/ZnO i-layer. This study aims to reduce interface recombinations and eliminate electrical barriers in Cu(In,Ga)S2 solar cells using a combination of Zn1−x Mg x O and Al-doped Zn1−x Mg x O buffer and i-layer combination deposited using atomic layer deposition and magnetron sputtering, respectively. The devices prepared with these layers are characterized by current–voltage and photoluminescence measurements. Numerical simulations are performed to comprehend the influence of electrical barriers on the device characteristics. An optimal composition of Zn1−x Mg x O (x = 0.27) is identified for a suitable conduction band alignment with Cu(In,Ga)S2 with a bandgap of ∼1.6 eV, suppressing interface recombination and avoiding barriers. Optimized buffer composition together with a suitable i-layer led to a device with 14% efficiency and an open-circuit voltage of 943 mV. A comparison of optoelectronic measurements for devices prepared with zinc oxide (ZnO) and Al:(Zn,Mg)O shows the necessity to replace the ZnO i-layer with Al:(Zn,Mg)O i-layer for a high-efficiency device.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.