Electric current effects on bond strength, nanoleakage, degree of conversion and dentinal infiltration of adhesive systems

Abstract

To evaluate the effect of three adhesive systems applied under electric current on microtensile bond strength (μTBS) and degree of conversion (DC). Molar teeth were restored with the aid of three adhesive systems (Adper Single Bond 2—SB2; Clearfil SE Bond—CSE; and Single Bond Universal—SBU) under different electric current intensities (0 μA; 25 μA; and 50 μA). Composite resin blocks were built up in increments (2 mm) and sectioned into 1 × 1 mm beams. The μTBS was tested after 24 h and 1 y distilled water storages. Samples (n = 10) from 24 h to 1 y storages were immersed in a 50% ammoniacal silver nitrate solution and submitted to scanning electron microscopy. The silver nitrate in the hybrid layer was quantified (ImageJ software). The adhesive systems' dentinal infiltration was analyzed using confocal laser scanning microscopy. Fourier transform near infrared spectroscopy was used to measure the DC. The μTBS data were submitted to two-way ANOVA (time vs. electric current) and Bonferroni's test (α = 0.05). Quantitative nanoleakage data were submitted to two-way ANOVA (electric current vs. adhesive) and Bonferroni's test (α = 0.05). DC data were submitted to one-way ANOVA and Tukey's test (α = 0.05) for each adhesive system. The electric current statistically increased the μTBS for SB2 and CSE in 24 h storage, as well as for SB2, CSE and SBU in 1 y storage. No significant difference was observed between storage time for CSE and SBU. When compared to the control, electric currents (25 μA and 50 μA) showed significantly higher DC mean values for SB2 and SBU, and had no effect on CSE. The electric currents (25 μA and 50 μA) reduced the adhesive system's nanoleakage after 1-year storage, and improved the infiltration of SB2 and CSE. Both electric current intensities improved dentinal interface stability.