Abstract
A test object for 3D-ultrasound (US) imaging equipment was constructed, that could be used for various purposes: For training of the correct technical setup procedures and practical handling of a 3D-US equipment, as well as for various quality assurance procedures. The size and volume of these structures were known precisely (± 0,1 mm resp. ± 0,06 mL, respectively; smallest volume: 0,1 mL). The stability of the structures was in agreement with guideline IEC 854 and allowed to quantify exactly the imaging and measurement errors of size and volume measurements performed with commercial 3D-equipment. The test object is well suited to validate measured volume data, as well as to perform procedures of technical quality assurance in a reproducible manner.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
