Abstract
Developing low-cost nano-biomaterials using locally available raw materials is gaining significant prominence recently, e.g., to meet the UN’s sustainable development goals (Goal 3). In this work, amorphous calcium silicate (CaS) nanopowders were prepared from Egyptian corals (CaCO3) as a low-cost bone restoration material due to their excellent bonding abilities with surrounding bone tissues, which in turn accelerated the bone healing process. Some of the developed CaS nanopowders was doped with different concentrations of Cu2+ and Zn2+ at the expense of the inherent Ca2+ in the raw materials. The nanopowders were characterized using X-ray diffraction (XRD), Fourier transform infrared spectra (FTIR), scanning electron microscope with energy-dispersive X-ray spectrometry (SEM-EDX), transmission electron microscope (TEM) and Brunauer-Emmett-Teller (BET) surface area measurements. Mechanical and bactericidal properties of the nanopowders were assessed followed by well-defined examinations of their abilities to support cell viability, proliferation and differentiation against osteosarcoma cells (MG63 cell lines). The obtained nanopowders were confirmed to be amorphous in nature with particle diameters mostly in two size ranges, namely, 5–10 nm and 15–92 nm. The nanopowders were found to have a good surface area influenced by the type of dopant materials. Notable enhancement in the mechanical (up to 6.76 MPa compressive strength) and antibacterial behaviors of the CaS nanopowders were observed after Zn2+ doping. The number of the differentiated cells after 72 h of incubation was increased, especially for CaS silicate Zn2+ doped nanopowders. Following these examinations of the nanopowders, their utility for the treatment of calvarial (top part of the skull) defects in a rat model was investigated. The developed Cu2+ or Zn2+ doped nanopowders enhanced the healing rate of calvarial defects and they demonstrated impressive biosafety towards repairing vital organs (brain, liver and kidney).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Colloids and Surfaces A: Physicochemical and Engineering Aspects
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.