Abstract
This paper presents the design procedure of an efficient compact monolithic microwave integrated circuit power amplifier (MMIC PA) in a 0.1 μm GaN-on-Si process for 5G millimeter-wave communication. Load/source-pull simulations were conducted to correctly create equivalent large-signal matching models for stabilized power cells and to determine the optimal impedance domain. The shorted stub with bypass capacitors minimizes the transistor’s output reactance, simplifying the matching objective to an approximate real impedance transformation (IT). With miniaturization as the implementation guide, explicit formulas and tabulated methods based on mathematical analysis were applied to synthesize the filtering matching networks (MNs) for the input and output stages. In addition, a CAD-dependent numerical optimization approach was used for the interstage MN that needs to cope with high IT ratio and complex loads. The continuous-wave (CW) characterization for the proposed two-stage PA demonstrated 19.8 ± 0.7 dB of small-signal gain, very flat output power (Pout) and power-added efficiency (PAE) at 4 dB gain compression of 32–32.4 dBm and 34–34.6%, respectively, over 24–30 GHz, with 37.1% of peak PAE at mid-frequency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.