Abstract

The filtration efficiency for separating liquid paraffin (or water) from a slurry consisting of 25 weight% spherical alumina in a Slurry Bubble Column Reactor (SBCR) comprised of a cylindrical tube of 10 cm diameter and 150 cm length was studied. Various differential pressures (?P) were applied to two separate tubular sintered metal stainless steel filter elements with nominal pore size of 4 and 16?m. The experimental results disclosed that the rate of filtrations increased on applying higher differential pressure to the filter element. Albeit this phenomenon is limited to moderate ?Ps and for ?P more than 1 bar is neither harmful nor helpful. The highest filtration rates at ?Ps higher than 1 bar were 170 and 248 ml/minute for 4 and 16?m respectively. Using water as the liquid in slurry the rate of filtration enhanced to 4 folds, and this issue reveals impact of viscosity on filtration efficiency clearly. In all situations, the total amount of particles present in the filtrate part never exceeded a few parts per million (ppm). The statistical analysis of the SEM image of the filtrate indicated that by applying higher pressure difference to the filter element the frequency percent of larger particle size increases. The operation of filter cake removing was performed with back flashing of 300 ml of clean liquid with pressures of 3-5 bar of N2 gas.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.