Abstract

The integration of cobalt borate OER catalysts with electrodeposited BiVO4-based photoanodes through a simple drop casting technique was shown to provide an improvement of the photoelectrochemical performance of electrodes under simulated solar light. Catalysts were obtained by chemical precipitation mediated by NaBH4 at room temperature. Scanning electron microscopy (SEM) investigation of precipitates showed a hierarchical structure with globular features covered in nanometric thin sheets providing a large active area, whereas X-ray diffraction (XRD) and Raman spectroscopy highlighted their amorphous structure. The photoelectrochemical behavior of samples was investigated by linear scan voltammetry (LSV) and electrochemical impedance spectroscopy (EIS) techniques. The amount of particles loaded onto BiVO4 absorbers was optimized by variation of the drop cast volume. The enhancement of photocurrent generation by Co-Bi-decorated electrodes with respect to bare BiVO4 was observed with an increase from 1.83 to 3.65 mA/cm2 at 1.23 V vs RHE under AM 1.5 simulated solar light, corresponding to a charge transfer efficiency of 84.6%. The calculated maximum applied bias photon-to-current efficiency (ABPE) value for optimized samples was 1.5% at 0.5 V applied bias. Under constant illumination at 1.23 V vs RHE, a depletion of photoanode performances was observed within an hour, likely due to the detachment of the catalyst from the electrode surface.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.