Efficiency of municipal packaging waste recovery chain and suitability of separated residual waste fractions for use in alternative fuels production

Abstract

Due to the sheer quantity and quality of material, packaging waste is separately collected by municipal waste management systems, with a primary goal of its use in material recovery. The residual waste, i.e. rejected waste in the separation process can be energy recovered. Both recovery options have specific input material quality requirements. Therefore, it is important to know the characteristics of individual waste streams. This research analysed the composition and morphological characteristics of separately collected packaging waste from municipal waste management system, residual (rejected) waste fractions after separation steps and produced refuse-derived fuel (RDF). The efficiency of primary and secondary (manual) waste separation, as well as of the RDF production step, are tracked. Results show that primary waste separation produces material with under 7% of contaminants and secondary manual waste separation efficiency ranges between 45% and 55%. Physico-chemical comparison of simulated RDF strongly coincides with analysed properties of RDF as a final product which indicates very high separation efficiency in the RDF production. From the energy recovery/conversion standpoint, this can be quantified through deviations in the lower heating value (LHV) and the effective H/C molar ratio between simulated and real RDF samples, which are on the level of 1.8% and 1.1% respectively. The following conclusion can be made from the estimated relation between changes in separation efficiency and RDF energy-related characteristics; the separation efficiency of individual components plays important role in alternative fuel production as chemical compositions directly influence suitability for high-quality liquid fuel production. Results of this analysis shed a light on the connection between aspirations to increase material recovery share and the suitability of produced residual waste for further recovery and valorisation. The material and energetic valorisation are competitors, and further evaluation should be done to understand the investments needed to increase valuable fractions of wastes separation that, in turn, could diminish the energetic value of residual fractions and, therefore, the economic viability of energy recovery facilities.