Abstract
Fuel cell hybrid vehicles represent an alternative to battery electric vehicles and will gain importance in the future as they do not need large battery capacities and thus require less critical raw materials. Depending on the electric architecture, the voltage of the fuel cell stack and traction battery may overlap. Accordingly, it is necessary to use a bidirectional DC–DC converter that connects the battery to the DC bus, which supports overlapping input and output voltages. Furthermore, these converters should be non-isolating in terms of compact design. Concerning complexity and controllability, the bidirectional cascaded buck and boost converter is preferable and is the subject of this study. Published literature presents the bidirectional cascaded buck and boost converter with high losses for overlapping input and output voltages, introducing two methods for this operation mode. The method selected for this study, namely buck + boost, uses two switches, whereby one switch has a fixed duty cycle. However, there is no appropriate investigation to determine the impact of this fixed duty cycle on converter efficiency to date. Furthermore, efficiency improvement is possible by switching frequency modulation, but current literature does not address this modulation method for overlapping input and output voltages. Therefore, this paper investigates a non-isolated hard-switched bidirectional cascaded buck and boost converter for fuel cell hybrid vehicles operating with up to 19.8 kW. The study focuses on determining the optimum fixed duty cycle and efficiency optimisation through a novel critical conduction mode with adapted switching frequency by utilising the load-dependent inductance of the inductor with powder cores. Measurements with an experimental setup validate the proposed modulation method with Si-IGBT half-bridge modules. The results demonstrate that a loss reduction of 39% is possible with switching frequency modulation and the optimum duty cycle compared to fixed switching frequency. As a result, the converter achieves high efficiencies of up to 99% and low device junction temperatures.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
