Abstract
The CdTe∕CdS solar cell devices were grown using a dry process consisting of sputtering for the transparent conducting oxide and CdS window layers, and close-space sublimation for CdTe absorber layer. These devices were back contacted using Mo∕Sb2Te3 sputtered layers following the CdCl2 activation process carried out in air. It was shown that when oxygen is intentionally introduced in the CdTe layer during its growth, this leads to a significant improvement in all the device parameters yielding an efficiency of 14% compared to 11.5% for devices fabricated in the same conditions but without intentional oxygen incorporation in CdTe. The data obtained were not altered following a light soaking. The devices were investigated by quantitative secondary ion mass spectrometry, which allowed insight into the distribution and amount of oxygen and chlorine within the entire device structure. Both impurities showed an increased concentration throughout the CdTe absorber layer.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
