Abstract
The article presents the influence of a superficial strengthening system on the behaviour of AAC-block walls with thin bed joints and unfilled head joints. The strengthening system consisted of a high-strength fibreglass mesh applied to both wall surfaces with a mineral mortar reinforced with fibreglass. A series of strengthened and unstrengthened specimens was tested under diagonal compression according to ASTM E519-15 to determine their shear strength and stress-strain characteristics. The use of optical strain measurement made it possible to identify the failure mode for both types of the tested walls. The strengthening system changed the wall failure development, which was initiated by unfilled head joints in both cases. The application of the strengthening system on both wall surfaces improved the strength properties of the wall significantly. The load-bearing capacity of the specimens increased by nearly 90% and cracking of the walls occurred at loads about 50% higher compared to specimens with no superficial strengthening. The strengthened specimens exhibited a ductile behaviour after reaching the maximum bearing capacity. A simplified method for computing the cracking load and maximum load was also proposed, the results of which are consistent with the tests results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
