Abstract

ObjectivesAssessment of Vitamin D status by measurement of 25-Hydroxyvitamin D (25-OH-D) is widely performed by immunoassay. Yet, the ability of these assays to detect Vitamin D2 (as 25-OH-D2) or Vitamin D3 (as 25-OH-D3) varies. It is important to recognize the ability of an assay to quantitate either form of 25-OH-D to evaluate Vitamin D status of supplemented patients. We evaluated detection of 25-OH-D2 and 25-OH-D3 by two assays in our medical center. Design and methodsThe Abbott Architect i1000 SR 25-OH Vitamin D assay and Roche Cobas 8000 Vitamin D assay were compared for their recovery of 25-OH-D2 or D3 from spiked serum samples. Samples with known endogenous concentrations of 25-OH-D2 or D3 by LC-MS/MS were also measured to calculate bias between our assays and LC-MS/MS. ResultsRecovery of 25-OH-D3 in spiked samples was similar by Architect (84–87%) and Cobas (90%). Recovery of 25-OH-D2 was lower than 25-OH-D3, and was poorer by Architect (37–40%) than by Cobas (69–71%). In measurement of samples with known 25-OH-D concentrations, performance of Architect and Cobas assays was similar for 25-OH-D3. However, at concentrations >50 nmol/L 25-OH-D2, the Architect assay exhibited large average negative bias (−27%). ConclusionsWhile the Architect and Cobas assays performed similarly in detection of 25-OH-D3, the Architect assay was significantly poorer at detecting 25-OH-D2 than Cobas, with poorer recovery and significant negative bias at higher concentrations of 25-OH-D2. This agrees with other studies, and indicates that caution should be used in interpreting Architect 25-OH-D results in patients supplemented with Vitamin D2.

Highlights

  • Measurement of 25-Hydroxyvitamin D (25-OH-D) is commonly performed to assess Vitamin D status in clinical laboratories

  • We evaluated the performance of our institution's total 25-OH-D assay on the Abbott Architect i1000 SR platform to detect either 25OH-D2 or 25-OH-D3

  • Samples were spiked with 130 nmol (50 ng) 25-OH-D2 or 25-OH-D3, or methanol as a solvent control to 1% of the final sample volume. 25-OH-D2 and 25-OH-D3 stock solutions were purchased from Millipore-Sigma and working solutions were made in methanol

Read more

Summary

Introduction

Measurement of 25-Hydroxyvitamin D (25-OH-D) is commonly performed to assess Vitamin D status in clinical laboratories. Vitamin D can be synthesized in skin from 7-dehydrocholesterol following ultraviolet light exposure, which produces Vitamin D3 (cholecalciferol). Vitamin D2 (ergocalciferol) is present in plant sources, and can be absorbed from the diet. Both D2 and D3 are subsequently converted to 25-OH-D by 25-hydroxylase activity in the liver.

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call