Efficacy of diffusion tensor imaging in identification of degenerative cervical spondylotic myelopathy

Abstract

Aim and objectivesTo study the diagnostic accuracy of Diffusion tensor imaging technique in detection of cervical spondylotic myelopathy changes. Material and methodStudy population included 50 patients with symptoms of cervical myelopathy. The patients were evaluated based on symptoms using the European myelopathy scoring system and were divided into: Grade 1, including patients with mild symptoms; Grade 2, referring to patients with moderate symptoms and Grade 3, which included patients revealing severe symptoms. All the patients were investigated with a 1.5 T MRI unit acquiring DWI and DTI sequences. FA and ADC values from each spinal segment were analyzed in terms of Frequency, Percentage, Mean, Standard Deviation and Confidence Intervals. The comparison of values was done by ANOVA and post hoc analysis by bonferroni test. Comparison of accuracy of FA, ADC and T2WI in recognizing myelopathic changes was done by t-test. Receiver Operating Characteristics (ROC) analysis was performed to obtain a cut off value of FA and ADC for each spinal level to identify myelopathic change in the spinal cord. ResultsThe study revealed a significant difference in the mean FA and ADC value of stenotic and Non-stenotic segments. T2WI was highly significant (p = 0.000) in recognizing myelopathy changes in patients falling under Grade 2(moderate) and Grade 3(severe) according to European Myelopathy scoring system. Regarding patients under Grade 1 (mild) FA and ADC values showed significant difference compared to T2WI. The collective sensitivity in the identification of myelopathic changes was highest with FA (79%) as compared to ADC (71%) and T2WI (50%). ROC analysis was done to determine the cut off values of FA and ADC at each cervical spine segments. The proposed cut off, for FA and ADC at the level of C1–C2 is 0.68 and 0.92, C2–C3 is 0.65 and 1.03, C3–C4 is 0.63 and 1.01, C4–C5 0.61 and 0.98, At C5–C6 0.57 and 1.04, At C6–C7 0.56 and 0.96 respectively. ConclusionFA and ADC values enhance the efficacy and accuracy of MRI in the diagnosis of cervical spondylotic myelopathy. Hence diffusion tensor imaging can be used as a non-invasive modality to recognize spondylotic myelopathy changes even in the early stages, which can be helpful in deciding on appropriate timing of decompression surgery before the irreversible chronic changes set in.