Abstract
0.05Pb[Fe1/2 Nb1/2]O3-0.05Pb[Ni1/3Nb2/3]O3-0.90Pb[ZrxTi(1-x)]O3 [PFN-PNN-PZT] quaternary piezoelectric ceramics with varying Zr/Ti ratios located near the morphotropic phase boundary (MPB) were prepared by a conventional mixed-oxide route. The samples structure was determined by X-ray diffractometry which indicate that the phase structure, of sintered PFN-PNN-PZT ceramics, was transformed from tetragonal to rhombohedral with Zr/Ti ratio increased in system. The effect of Zr/Ti ratio and sintering temperature on the structure and piezoelectric properties of our simples were investigated. The new MPB in this quaternary system with optimum piezoelectric properties was found at x = 0.51-0.53. The dependence of the piezoelectric coefficient (d31), electromechanical coupling factor (kp) and the dielectric constant (ε) on the Zr/Ti ratio shows a pronounced maximum of d31 = 141* 10-12 C/N, kp= 0.64 and ε = 850 at Zr/Ti : 51/49. As the Zr/Ti ratio increases, the Tcof PFN-PNN-PZT ceramics decreases and consequently the peak in the dielectric spectrum corresponding to the Tc moves towards room temperature. A Tc of 360 °C is obtained when Zr/Ti: 51/49.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Applied Engineering Science & Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
