Effects of Viscosity Ratio on Morphological, Rheological and Mechanical Properties of PP/PBT Melt Spun Alloy Fibers

Abstract

Phase morphology formation plays an important role in the mechanical properties of polymer alloy fibers. The development of the blend morphology depends not only on the intrinsic properties of the component polymers but also on extrinsic factors such as viscosity ratio, λ, in the melt spinning process. The effects of blend component viscosity ratio on the morphological, rheological, and mechanical properties of polypropylene/poly(butylene terephthalate) (PP/PBT) melt spun alloy fibers were investigated. Accordingly, two kinds of PP as matrix phase and two kinds of PBT as dispersed phase, with various melt viscosity, were physically mixed and then blended during the extrusion step of melt spinning. SEM micrographs and rheological and mechanical properties evaluations showed that the morphology of PP/PBT alloy fibers strongly depend on the viscosity ratio, λ. Finer diameter PBT fibrils were observed for Viscosity ratios less than 1 (λ < 1) compared to samples with λ > 1. The best mechanical properties in alloy fiber samples were obtained for the viscosity ratio closest to unity (sample with λ = 0.9). The lowest differences among measured complex viscosities at various shear rates (0.1, 10, and 100 s−1) were also observed in samples with λ = 0.9. The results showed that the mechanical properties of alloy fiber samples are affected not only by morphological properties observed at different viscosity ratios but also by the properties of the individual polymer components.