Effects of time-dependent deformation of shale on the integrity of a geological nuclear waste repository

Abstract

Safety assessment of geological nuclear waste repositories is essential for the permanent disposal of spent nuclear fuels and high-level radioactive waste. The long-term integrity of the host rock as well as the engineered barrier system (e.g., bentonite buffer) surrounding nuclear waste canisters is of particular importance as decay heat from nuclear waste canisters, which will last over thousands of years, significantly disturbs the thermo-hydromechanical (THM) state of the repository. In this study, THM coupled simulations were carried out to investigate the effect of time-dependent deformation (i.e., creep) of shale on the long-term integrity of a generic subsurface nuclear waste repository. The Norton-Bailey creep model, which is also known as the Lemaitre-Menzel-Schreiner model, was employed to simulate the power-law type creep that is observed in shales. The TOUGH-FLAC simulator was employed for the THM coupled modeling of the repository. The objective of this study is to assess the effect of creep in different shales (i.e., high creep shale vs. low creep shale) on long-term stress and permeability changes in the repository. Results show potential advantages of constructing repositories in the high creep shale, as deviatoric stress levels in the formation decreased to zero in 100 years since the emplacement of nuclear waste canisters and the permeability also decreased to the undamaged, intrinsic levels in 10,000 years. Also, mean effective stress levels in the bentonite buffer increased by 100% in the high creep shale case relative to the low creep shale case at 10,000 years due to creep-induced contraction of the nuclear waste disposal tunnel. However, in earlier periods (e.g., 1000 years), the stress levels in the bentonite buffer were twice smaller in the high creep shale case than in the low creep shale case, which shows a tradeoff between the intermediate- (∼1000 years) and long-term (>10,000 years) compaction levels in the bentonite buffer depending on the creep characteristics of the host shale.