Abstract
Both experimental and simulation studies were run to investigate the deformation uniformity of tailor-welded tube hydroforming with dissimilar thickness. The effects of weld-seam location and difference in thickness were analysed in detail. There are indications that obvious differences in deformation states appear between thinner and thicker tubes owing to poor deformation uniformity, which induces fluctuation in axial strain distribution, especially in the weld-seam zone nearby. Consequently, excessive thinning takes place on the thinner tube. Deformation uniformity improves as the length ratio increases or the thickness ratio decreases. However, it is more sensitive to the thickness ratio, and hence more effective for improving deformation uniformity by optimizing structure design.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.