Effects of thermal treatment on the characteristics of boron and tantalum-doped ZnO thin films deposited by the electrospraying method at atmospheric pressure

Abstract

Metal-doped (B and Ta) ZnO thin films were deposited by the electrospraying method onto a heated glass substrate. The structural, electrical and optical properties of the films were investigated as a function of dopant concentration in the solution and also as a function of annealing temperature. The results show that all the prepared metal-doped ZnO films were polycrystalline in nature with a (0 0 2) preferred orientation. As the amounts of dopant were increased in the starting solution, the crystallinity and transmittance decreased. On the other hand, heat treatment of the films enhanced the transmittance, Hall mobility, carrier concentration and crystallinity. It was also observed that 2at.% is the optimal doping amount in order to achieve the minimum resistivity and maximum optical transmittance. As-deposited films have high resistivity and low optical transmittance. The annealing of the as-deposited thin films in air resulted in the reduction of resistivity. Depending on the characteristics of dopant, mainly ionic radius, the effects of dopant were studied on the properties of ZnO thin films. Boron and tantalum have been considered as dopants, tantalum being the superior of the two, since it showed the lower resistivity and higher carrier concentration as well as higher mobility. The minimum value of resistivity was 1.95×10−4Ωcm (15Ω/□) with an optical transmittance more than 93% in the visible region and minimum resistivity of 2.16×10−4Ωcm (18Ω/□) with an optical transmittance greater than 96% for 2at. % tantalum- and boron-doped ZnO films respectively. The present values of resistivities were closer to the indium tin oxide (ITO) resistivity and also closest to the lowest resistivity values among the ZnO films that were previously reported. The prepared films exhibit the good crystalline structure, homogenous surface, high optical transmittance and low resistivity that are preferable for optical devices.