Abstract
A study on the effect of the vacuum assisted resin transfer moulding (VARTM) manufacturing process on the mechanical properties of cotton/epoxy composite is presented in this investigation. Woven cotton was used as reinforcing material embedded in epoxy resin. The woven cotton was treated with sodium hydroxide for one hour at concentrations of 0% to 20%. The tensile test showed that the untreated material had the highest ultimate strength and Young’s modulus. Observation of the fracture surface by scan electronic microscopy (SEM) was compared to the hand lay-up process as well as the results of the tensile test. The comparison showed that the VARTM process presents better mechanical properties than the hand lay-up process due to the reduction in discontinuities observed by means of optical microscopy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
