Abstract
ABSTRACTA gradual change in thermal oxide surface state from hydrophilic to hydrophobic was observed with time -delay in a clean room environment. Surface quality and reflectivity for the Al/Ti metal layers showed a strong dependency on the oxide surface state. From the hydrophilic oxide substrate, a lower (002) Ti preferred orientation was obtained than from hydrophobic ones. This resulted in a degraded (111) Al preferred orientation and rough metal surface. The RF-etch process increased the smoothness and hydrophobic surface property for the inter -metal dielectric (IMD) oxides, and therefore greatly improved Al/Ti surface quality. When conventional CMOS double layer metal interconnection process is performed, metal inter-line bridge yield was strongly affected by the surface state of substrate oxides.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
