Abstract
An experimental apparatus that uses a superconducting magnet and enables the simultaneous application of an alternating electric field with a frequency of up to 50 kHz and a magnetic field of up to 10 T was designed and assembled. Electromagnetic vibrations were induced in Al-7 wt pct Si alloy during solidification by simultaneous application of the two fields. The thorough investigation, which was carried out over wide ranges of intensity (an electromagnetic pressure range of 0 to 2.25×105 Pa) and frequency (0 to 50 kHz), clarified the effects of the two main parameters on the microstructural refinement brought about by electromagnetic vibrations. Low-intensity vibrations changed the highly columnar dendritic structure into one composed of large, equiaxed dendrites. As the intensity, and consequently, the magnetic pressure were increased, at about 0.93×105 Pa, fine isolated grains started to appear and dominated the structure as the pressure was increased further. At low frequencies, the structure was one with large, equiaxed dendrites, which disintegrated to form a fine and homogeneous structure as the frequency was increased. At about 1.5 kHz, the trend reversed and the structure gradually became a completely columnar dendritic one at frequencies higher than 10 kHz. Metallographic observations showed that the cavitation phenomenon has been a main factor behind the observed microstructural refinement. The effects of mechanical vibrations of the experimental apparatus were also investigated and found to have no contribution to the observed effects.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have