Abstract
The effects of temperature on the crystal structure of a natural epidote [Ca1.925 Fe0.745Al2.265Ti0.004Si3.037O12(OH), a = 8.890(6), b = 5.630(4), c = 10.150(6) Å and β = 115.36(5)°, Sp. Gr. P21 /m] have been investigated by means of neutron single-crystal diffraction at 293 and 1,070 K. At room conditions, the structural refinement confirms the presence of Fe3+ at the M3 site [%Fe(M3) = 73.1(8)%] and all attempts to refine the amount of Fe at the M(1) site were unsuccessful. Only one independent proton site was located. Two possible hydrogen bonds, with O(2) and O(4) as acceptors [i.e. O(10)–H(1)···O(2) and O(10)–H(1)···O(4)], occur. However, the topological configuration of the bonds suggests that the O(10)–H(1)···O(4) is energetically more favourable, as H(1)···O(4) = 1.9731(28) Å, O(10)···O(4) = 2.9318(22) Å and O(10)–H(1)···O4 = 166.7(2)°, whereas H(1)···O(2) = 2.5921(23) Å, O(10)···O(2) = 2.8221(17) Å and O(10)–H(1)···O2 = 93.3(1)°. The O(10)–H(1) bond distance corrected for “riding motion” is 0.9943 Å. The diffraction data at 1,070 K show that epidote is stable within the T-range investigated, and that its crystallinity is maintained. A positive thermal expansion is observed along all the three crystallographic axes. At 1,070 K the structural refinement again shows that Fe3+ share the M(3) site along with Al3+ [%Fe(M3)1,070K = 74(2)%]. The refined amount of Fe3+ at the M(1) is not significant [%Fe(M1)1,070K = 1(2)%]. The tetrahedral and octahedral bond distances and angles show a slight distortion of the polyhedra at high-T, but a significant increase of the bond distances compared to those at room temperature is observed, especially for bond distances corrected for “rigid body motions”. The high-T conditions also affect the inter-polyhedral configurations: the bridging angle Si(2)–O(9)–Si(1) of the Si2O7 group increases significantly with T. The high-T structure refinement shows that no dehydration effect occurs at least within the T-range investigated. The configuration of the H-bonding is basically maintained with temperature. However, the hydrogen bond strength changes at 1,070 K, as the O(10)···O(4) and H(1)···O(4) distances are slightly longer than those at 293 K. The anisotropic displacement parameters of the proton site are significantly larger than those at room condition. Reasons for the thermal stability of epidote up to 1,070 K observed in this study, the absence of dehydration and/or non-convergent ordering of Al and Fe3+ between different octahedral sites and/or convergent ordering on M(3) are discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.