Abstract
A model for calculating surface roughness effect on the intensity of emitted X-rays in the soft and ultrasoft X-ray region is presented and discussed. The results of calculations based on this model are compared to the results obtained experimentally using Al gratings as models for rough surfaces. It is shown that the correspondence between calculated and experimental intensities for Al–K is sufficient to corroborate the use of this model as a means of estimating maximum allowable surface roughness without a significant loss in intensity. It is also shown that this maximum allowable roughness estimate can be calculated with a knowledge of only the sample density and wavelength of the X-ray emission.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
