Effects of supplemental zinc concentration and source on performance, carcass characteristics, and serum values in finishing beef steers.

Abstract

Three studies were conducted to examine the effects of zinc concentration or source in diets of finishing beef steers. In Exp. 1, 108 (British x Continental) beef steers were supplemented with concentrations of added zinc (as ZnSO4) at 20, 100, or 200 mg/kg of dietary DM. No differences (P > 0.10) were noted among treatments for ADG or gain:feed for the 112-d finishing period. However, a linear (P < 0.10) decrease was noted in daily DMI with increasing zinc concentrations for the overall finishing period. No differences (P > 0.10) were noted in hot carcass weight; dressing percentage; longissimus muscle area; percentage of kidney, pelvic, and heart fat; or marbling score. There were, however, quadratic increases in s.c. fat thickness (P < 0.05) and yield grade (P < 0.01) with added zinc. In Exp. 2, 12 beef steers were used to examine effects of added dietary zinc on serum concentrations of cholesterol and fatty acid profiles. No differences (P > 0.10) were observed in cholesterol or fatty acids among the supplemental zinc levels. In Exp. 3, 84 Brangus- and Angus-sired steers were fed a steam-flaked corn-based diet containing 30 mg of supplemental zinc per kilogram of dietary DM from one of the following sources: 1) ZnSO4, 2) Zn amino acid complex, or 3) a zinc polysaccharide complex. No differences (P > 0.10) were noted for the overall 126-d trial for ADG, DMI, or gain:feed ratio. Percentage kidney, pelvic, and heart fat was increased (P < 0.10) in steers supplemented with ZnSO4 vs the average of Zn amino acid and Zn polysaccharide complexes. However, s.c. fat thickness was greater (P < 0.10) in steers supplemented with Zn amino acid and Zn polysaccharide complexes vs ZnSO4. Serum zinc concentration did not differ (P > 0.10) among zinc sources. Supplemental zinc concentration in finishing diets did not seem to influence feedlot performance and had a minimal impact on carcass quality. Either the organic or inorganic source can be included in finishing diets without affecting feedlot performance.