Effects of sucrose on egg white protein and whey protein isolate foams: Factors determining properties of wet and dry foams (cakes)

Abstract

The effects of sucrose on the physical properties of foams (foam overrun and drainage ½ life), air/water interfaces (interfacial dilational elastic modulus and interfacial pressure) and angel food cakes (cake volume and cake structure) of egg white protein (EWP) and whey protein isolate (WPI) was investigated for solutions containing 10% (w/v) protein. Increasing sucrose concentration (0–63.6 g/100 mL) gradually increased solution viscosity and decreased foam overrun. Two negative linear relationships were established between foam overrun and solution viscosity on a log–log scale for EWP and WPI respectively; while the foam overrun of EWP decreased in a faster rate than WPI with increasing solution viscosity (altered by sucrose). Addition of sucrose enhanced the interfacial dilational elastic modulus ( E′) of EWP but reduced E′ of WPI, possibly due to different interfacial pressures. The foam drainage ½ life was proportionally correlated to the bulk phase viscosity and the interfacial elasticity regardless of protein type, suggesting that the foam destabilization changes can be slowed by a viscous continuous phase and elastic interfaces. Incorporation of sucrose altered the volume of angel food cakes prepared from WPI foams but showed no improvement on the coarse structure. In conclusion, sucrose can modify bulk phase viscosity and interfacial rheology and therefore improve the stability of wet foams. However, the poor stability of whey proteins in the conversion from a wet to a dry foam (angel food cake) cannot be changed with addition of sucrose.