Effects of Strain State and Strain Rate on Deformation-Induced Transformation in 304 Stainless Steel: Part II. Microstructural Study

Abstract

The γ→α transformation in 304 stainless steel was induced by plastic deformation under various conditions of strain, strain state, and strain rate, and the transformation microstructures were examined by transmission electron microscopy (TEM). The nucleation of α martensite embryos was always confined to microscopic shear band (faults, twins, and e-martensite) intersections. In cases where shear bands consisted of bundles of intermixed faults, twins, and e-martensite, α nucleated preferentially only within specific portions of the intersection volume. At sufficiently large strains α appeared to grow into polyhedral shapes. We postulate that growth occurs by repeated nucleation of new α embryos and coalescence of such embryos into polyhedral shapes. These shapes can grow either within an active slip plane or out of it, depending on how many shear band intersections are produced during deformation. Actual measurements of the number of intersections indicated that more intersections are formed in biaxial tension per unit effective strain than in uniaxial tension. This accounts for the more irregular, blocky α morphology observed in biaxial tension. At high strain rates we also found an increase in the number of intersections. However, adiabatic heating at large strains and high rates restricts repeated nucleation and coalescence and limits the amount of α transformation product.